Tongue and Groove Cladding Applications

collapse section
expand section
Typical Wall Setups
Below are typical scenarios for Tongue and Groove Cladding setups on blockwork and studs.
Horizontal Cladding on Blockwork

tongue-and-groove-cladding-typical-horizontal-wall-setup-blockwork

*For interior applications, batten centres to be at 600mm centres.

 

Horizontal Cladding on Studs

tongue-and-groove-cladding-typical-horizontal-wall-setup-stud

*Interior studs spaced at 600mm centres
Exterior studs spaced at 450mm centres

 

Vertical Cladding on Blockwork

tongue-and-groove-cladding-typical-vertical-wall-setup-blockwork

*For interior applications, batten centres to be at 600mm centres.

 

Vertical Cladding on Studs

tongue-and-groove-cladding-typical-vertical-wall-setup-stud

*Interior battens spaced at 600mm centres.
Exterior battens spaced at 450mm centres.

Ceilings and Soffits

Sculptform’s Tongue and Groove cladding system can be used for interior ceilings and external soffits.

  • For interior ceilings, batten/joists at 600mm centres.
  • For external soffits, battens/joists at 600mm centres.
  • For suspended ceilings, consider the kg/m² weight of the cladding (see technical information) and consult your suspended ceiling provider.
Windows and other penetrations
Window Header Detail

Penetrations to cladding need a secure fixing point. Where the cladding meets a door, window, etc. framing should be available to secure the cladding. Smaller penetrations such as lights, pipes, etc. may not need a fixing point. Sealant should be used in these situations for appearance and external waterproofing.

Window and door penetrations could use our L-Profile to neaten the detail.

tongue-and-groove-cladding-penetrations-window-header

 

Window Side Detail

tongue-and-groove-cladding-penetrations-window-side

 

Window Base Detail

tongue-and-groove-cladding-penetrations-window-base

 

Doors
Frame Door Structure

tongue-and-groove-cladding-doors-frame

*Plan view – Horizontal Cladding

Applied to Solid Door

tongue-and-groove-cladding-doors-solid

* Cross section view – Horizontal Cladding
*Adhesive must be applied to the entirety of the back of the board to prevent moisture getting trapped behind the boards. Sculptform recommends Sikaflex 11FC.